PUMA SOM-RK3399-Q7 User Manual

• 1. Introduction
  • 1.1. Device Overview
• 2. First Steps
  • 2.1. Required Tools
  • 2.2. Insert the Module
  • 2.3. Mount the Heatsink
  • 2.4. Mount the Fan (optional)
  • 2.5. Power Up
• 3. Using the EVK
  • 3.1. Evaluation Board Overview
  • 3.2. Power Supply
  • 3.3. Control Buttons and Switches
  • 3.4. CPU Fan
  • 3.5. Boot Order
  • 3.6. USB Serial Console
  • 3.7. RS-232 and RS-485
  • 3.8. TTL UART
  • 3.9. Ethernet
  • 3.10. USB Interfaces
  • 3.11. Video
  • 3.12. RTC
  • 3.13. SPI, I2C and 1-Wire
  • 3.14. GPIOs
  • 3.15. Audio
  • 3.16. CAN Bus
  • 3.17. CTRL I/O Connector
  • 3.18. MISC Connector
• 4. Software Guide
  • 4.1. Architecture Overview
  • 4.2. Prerequisites
  • 4.3. Compile the Cortex-M0 power management firmware
  • 4.4. Compile the ATF
  • 4.5. Compile U-Boot
  • 4.6. Compile the Boot Script
  • 4.7. Compile the Linux Kernel
  • 4.8. Building the root filesystem
  • 4.9. Deploy on SD Card
  • 4.10. Deploy on SPI NOR-flash
  • 4.11. Deploy on On-Board eMMC storage
  • 4.12. Compiling Linux Applications
  • 4.13. Serial Number
  • 4.14. MAC Address
• 5. Hardware Guide
  • 5.1. Qseven Implementation
  • 5.2. Q7 Connector Pinout
  • 5.3. MIPI-CSI Feature Interface Pinout
  • 5.4. Signal Details
  • 5.5. On-board Devices
  • 5.6. USB
  • 5.7. Using Qseven Signals as GPIO
  • 5.8. Electrical Specification
  • 5.9. Mechanical Specification
• 6. Contact
• 7. Revision History